How to store the GO Series Waterbottle or Tumbler

When your LifeStraw GO Series bottle or tumbler isn’t in use, we recommend storing the membrane filter in a saltwater solution. This helps prevent mold and algae and keeps the filter moist for easy use later.

⚠️ Please do not store saltwater inside stainless steel bottles—it can cause rust.


Here’s how to store your filter properly:

  1. Remove Carbon Filter
  2. Let it dry for 30 minutes, then place it in a sealed bag or reusable container.
  3. Disinfect Membrane Filter
    • Mix ¼ tsp household bleach with 2 cups (0.5L) clean water.
    • Pour the solution into your bottle with the membrane filter installed. Close the lid and let it sit for 5 minutes.
    • Rinse twice with clean water, shaking for 30 seconds each time.
    • Blow air through the filter to remove any bleach residue.

      Prepare Saltwater Storage

    • In a non-metal container or zip-lock bag, mix 1 tsp salt with 0.5L water. Shake to dissolve.
    • Submerge the membrane filter in the solution and seal tightly.
    • Do not store this solution inside a stainless steel bottle.

      Store

    • Keep the membrane filter + saltwater in a cool, dry place.
    • Place the dry carbon filter in a sealed bag inside your bottle and close the cap.

When You’re Ready to Use It Again:

  • Reinsert the carbon filter.
  • Discard the salt solution and reinstall the membrane filter.
  • Fill the bottle with water and spit out the first few sips if they taste salty.
  • If stored for more than 3 months, we recommend replacing the carbon filter.

📽Check out our video on how to store your LifeStraw Go Series Bottle or Tumbler Long Term

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.